JNH Interlocking Yoke System

Each Nila module can be stacked side by side with any other Nila module. Slide the dove tails together until the top and bottom of each module is flush. Use the 3/16” allen wrench to tighten the two set-screws. Access to the set screws is at the top and bottom of each female dove tail. Slide the wrench through the hole and turn clockwise to tighten and counter clockwise to loosen.

Loosen tilt knobs when sliding the yoke onto the fixture. Yokes can be attached by sliding both the male and female dove tails down the sides of one or more Nila modules until the yoke holders are flush with the lights. Attach two 5/16” flat head screws to each side of each row of lights. You will need four screws for each row of lights. Example: A six-pack will need eight screws (4 for each row), whereas a single Nila will use 4 screws.

**Note**
On all of the yoke bases there is a 3/8-16 threaded hole for storing the “T” handle.

Important to remember:  Do not over tighten the set-screws. Hand tight is sufficient. It is not necessary to remove set-screws when one unit is not attached to another unit.

All screws on the Nila Lighting System use the same 3/16” allen wrench (interlocking set screws, yoke holder, lens, barn doors, and Chimera brackets).